Black ergonomic grips for MS Energy E10 – grip 120 mm, total 131 mm

Ergonomic black handlebar grips with dual locking clamps

This pair of black grips features a textured surface and extended palm rest. The locking clamps at both ends prevent the properly installed grips from rotating on the handlebars.

Features and fitment

• Model: MS Energy E10.
• Pair of ergonomic black handlebar grips with palm rests.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; dual locking clamps.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, with a total length including end caps of approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance near the throttle and brake lever; do not force the shorter right-side grip onto a twist throttle.

Palm rest and grip adjustment

• Remove the old grips and clean and dry the handlebars. Before tightening, ensure the new grip fits fully onto the intended tube section.
• Adjust the position to suit your wrist comfort and brake lever reach. Tighten the locking clamps (where present) according to instructions and ensure the grip does not rotate.
• Check for smooth throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.