Black ergonomic grips for MS Energy E20 – 120 mm grip, 131 mm total

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm support. Clamps on both ends restrict rotation of a properly installed grip on the handlebar.

Features and compatibility

• Model: MS Energy E20.
• Pair of ergonomic black grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Mount 22.2 mm; clamps on both ends.

Approximate dimensions

• Length of grip area: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Width of support: 44 mm.
• Mount diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance near the throttle and brake lever; do not force-replace the shorter right grip if you have a twist throttle.

Adjusting the support and grip

• Remove the old grips and clean and dry the handlebar. Before tightening, check that the new grip sits completely on the intended part of the tube.
• Adjust the position to your relaxed wrist and reach of the brake lever. Tighten the clamping parts, where present, according to the instructions and check that the grip does not rotate.
• Check the free return of the throttle. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.