Black ergonomic grips for MS Energy E21 – grip 120 mm, total 131 mm

Ergonomic black handlebar grips with clamps on both ends

This pair of black handlebar grips features a textured surface and extended palm rests. Clamps on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: MS Energy E21.
• A pair of black ergonomic handlebar grips with palm rests.
• Grip surface length 120 mm; total length 131 mm.
• Mounting diameter 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip surface length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Palm rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip surface measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Check the clearance around the throttle and brake lever before installation; do not force a replacement on the right side if the existing throttle is shorter.

Palm rest and grip adjustment

• Remove the old grips, then clean and dry the handlebars. Before securing, verify that the new grip sits fully on the designated section of the tube.
• Adjust the position for a relaxed wrist and comfortable brake lever reach. Tighten the clamping parts where present according to instructions and ensure the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.