Black ergonomic grips for MS Energy Urban X – grip 120 mm, total 131 mm

Ergonomic black grips with locking rings on both ends

The pair of black grips features a textured surface and extended palm support. Locking rings on both ends prevent the correctly installed grips from rotating on the handlebars.

Features and fitment

• Model: MS Energy Urban X.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Mounting 22.2 mm; locking rings on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Palm support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, with a total length of approximately 131 mm including the ends. The inner diameter is 22.2 mm. Check the space available next to the throttle and brake lever before assembly; do not force the installation of shorter right-side grips next to a twist-grip throttle.

Support and grip adjustment

• Remove the old grips, then clean and dry the handlebars. Before tightening, ensure the new grip sits fully on the designated part of the handlebar tube.
• Adjust the position for a relaxed wrist angle and easy access to the brake lever. Tighten the locking rings (where present) according to instructions and ensure the grip does not rotate.
• Verify that the throttle return is unobstructed. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.