Ceramic brake pads for NUTT calipers with cooling fins

Ceramic brake pads with cooling fins for NUTT calipers

This pair of ceramic brake pads features black backings with tall cooling fins, rectangular friction material, and a hole for a retaining pin. The fins increase the surface area for heat dissipation, while the metal spreader spring and cotter pin complete the set for one compatible NUTT brake caliper.

Features and fitment

• Brake pad compound: ceramic.
• Black backings with cooling fins; pair with spring and cotter pin.

Approximate dimensions

• Dimensions with cooling fins: 41.3 x 42.4 mm.
• Maximum fin depth: 13.5 mm.
• Retaining pin hole diameter: 3.2 mm.

The backing plate measures approximately 41.3 x 42.4 mm, with a maximum depth including fins of 13.5 mm. Before replacing, verify the clearance above the caliper, the shape of the old pad, and the position of the retaining pin hole.

For use only with installed NUTT calipers that match this pad shape and mounting type.

Brake pad compound

The ceramic compound forms the friction surface of these pads. For even contact with the rotor, bed in the new pair gradually after installation. Keep the pads clean and dry; oil or grease on the friction surface will significantly reduce braking performance.

When to replace and how to install

• Inspect pads if braking becomes weak, uneven, or contaminated. Replace both pads in the same caliper; check the brake manual for minimum thickness requirements.
• Remove the retaining pin and old pads. Follow the procedure for your specific brake caliper to prepare the space for new pads, then insert the spring, new pair, and retaining pin. Do not grease the friction surfaces.
• Check for free wheel rotation and brake lever operation. Bed in the new pads by performing several gradual stops in a safe area, without locking the wheels.