FT76X half-twist throttle with grips – SM-3P

Half-twist throttle with matching grips

The black FT76X half-twist throttle is complemented by a short right grip and a longer left grip with a palm rest. The approximately 1.6 m long cable ends in a 3-pin SM connector.

Features and fitment

• FT76X half-twist throttle handle.
• SM-3P connector and approx. 1.6 m of cable.
• Set with matching black handles.

The handle is intended for compatible control systems of vehicles with a 12–72 V battery. Connect it to the designated controller signal input and verify sensor power supply and pinout. Do not connect signal wires directly to the battery.

Installation and response check

• Before replacement, turn off the vehicle and disconnect the power supply following the service procedure. Compare the contacts and plug in the connector without forcing.
• Route the cable without tension at full handlebar turn. Secure the handle so the moving part has enough clearance and returns immediately after release.
• Before riding, check the throttle response and brake motor cut-off under controlled conditions. Do not use a stuck or damaged handle.