NUTT Y5 hydraulic brake set for VSETT 11+

NUTT Y5 hydraulic brake kit for VSETT 11+

The kit for the front and rear brakes of the VSETT 11+ model includes left and right NUTT Y5 levers, two black calipers, and hydraulic hoses of different lengths. The signal cables on the levers are intended for the motor cut-off function during braking.

Contents and dimensions

• Front hose: 1300 mm; rear hose: 2100 mm according to the supplier.
• Two NUTT Y5 levers, approximately 180 mm long, with a clamp diameter of approximately 22.5 mm.
• Lever signal cables: approximately 384 mm, with red-marked connectors.
• The pictured caliper measures approximately 88.6 × 61.5 × 44 mm; the bolt hole spacing is approximately 52 mm.
• Hose connection fittings and screws shown in the photos are included.
• Brake discs are not included.

Fitment and installation

When installing on a VSETT 11+, check the mounting side of both calipers, the brackets, the diameter and thickness of existing discs, and the signal connectors. The hoses must allow for proper routing without tension during full handlebar rotation and suspension movement. When retrofitting existing brakes, appropriate adapters may be required; the same bolt spacing alone does not guarantee the correct pad position on the disc.

Installation and use

Installation, hose connection, and bleeding should be performed by a qualified technician. Before use, verify sealing, free rotation of both wheels, brake motor cut-off function, and properly bed in the pads.