ULIP sintered brake pads for Kugoo G2 Pro – 22.4 × 33.5 × 4.0 mm

Round sintered ULIP pads with upper tab

The ULIP Sintered pair has a round friction area, an extended upper tab, and a spacer spring. The bronze-colored backplates measure approximately 22.4 × 33.5 mm, and the total thickness of each pad is 4 mm.

Features and compatibility

• Model: Kugoo G2 Pro.
• Brake compound: sintered metal – ULIP Sintered.
• ULIP Sintered, sintered brake pads.
• Bronze-colored round backplates with tab and spacer spring.
• Approximate dimensions 22.4 × 33.5 × 4 mm.

Approximate dimensions

• Pad: 22.4 × 33.5 × 4 mm.
• Upper tab width: 6.4 mm.
• Rectangular opening: 3.8 × 1.8 mm.

Also compare the lower notch and the tab position. This outline is not identical to fully round pads without an extension; after replacement, the spring must correctly push both pads away from the disc.

Brake compound

Sintered metal compound generally handles heat and wear well in wet conditions. Compared to organic, it can be louder and cause more disc wear. Use a disc that allows metal pads.

When to replace and how to start

• Inspect the pads in case of reduced braking performance, uneven wear, or contamination. Replace both pads in the same caliper; check your brake manual for the minimum allowed thickness.
• Following the mechanical caliper instructions, remove the old pair and loosen the adjustment for the new pads. Install both pads and the spacer spring, then adjust the gap at the disc. Do not grease the friction surfaces.
• Check for free wheel rotation and lever operation. Bed in the new pads by performing several gradual stops in a safe area without locking the wheel.