Black ergonomic grips for Hiley Tiger 10 V4 VLR – 120 mm grip, 131 mm total

Ergonomic black grips with locking rings on both ends

This pair of black grips features a textured surface and extended palm rest. The locking rings on both ends prevent the properly installed grips from rotating on the handlebars.

Features and fitment

• Model: Hiley Tiger 10 V4 VLR.
• Pair of black ergonomic grips with palm rest.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; locking rings on both ends.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Palm rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance next to the throttle and brake lever; do not force the installation of shorter right-hand grips near the twist throttle.

Palm rest and grip adjustment

• Remove the old grips, then clean and dry the handlebars. Before fastening, ensure that the new grip sits completely on the intended part of the tube.
• Adjust the position to suit a relaxed wrist and reach to the brake lever. Tighten the locking components where present according to instructions and ensure the grip does not rotate.
• Check for free return of the throttle. Replace torn, hardened, or slippery grips; do not apply lubricants to the gripping surface.