Black ergonomic grips for Hiley Tiger 10 V5 Performance

Ergonomic black grips with locking rings on both ends

The pair of black grips features a textured surface and an extended palm rest. Locking rings on both ends prevent the correctly installed grip from rotating on the handlebars.

Features and fitment

• Model: Hiley Tiger 10 V5 Performance.
• Pair of black ergonomic grips with palm rest.
• Grip section 120 mm; total length 131 mm.
• Fitment 22.2 mm; locking rings on both ends.

Approximate dimensions

• Grip length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, with a total length including end caps of approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance near the throttle and brake lever; do not force the replacement of shorter right-hand grips near the twist throttle.

Adjusting the rest and grip

• Remove the old grips and clean and dry the handlebars. Before fastening, ensure that the new grip sits fully on the intended part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the locking sections where present according to instructions and check that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricants to the grip surface.