Black ergonomic grips for Hiley Tiger 9 Pro – grip 120 mm, total 131 mm

Ergonomic black grips with dual locking clamps

This pair of black grips features a textured surface and flared palm support. The locking clamps on both ends prevent the properly installed grips from rotating on the handlebars.

Features and fitment

• Model: Hiley Tiger 9 Pro.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Clamping diameter 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Palm support width: 44 mm.
• Clamping diameter: 22.2 mm.

The grip area measures 120 mm, with a total length including the ends of approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force the shorter right grip onto a twist throttle.

Adjusting support and grip

• Remove the old grips, then clean and dry the handlebars. Before tightening, ensure that the new grip sits perfectly on the designated handlebar section.
• Adjust the position for a relaxed wrist and comfortable brake lever reach. Tighten the clamping components (where applicable) according to instructions and ensure the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.