Black ergonomic handlebar grips for VSETT 10 Light

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and flared palm rest. Clamps on both ends prevent the correctly installed grip from rotating on the handlebar.

Features and fitment

• Model: VSETT 10 Light.
• Pair of black ergonomic grips with palm rest.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, with a total length of approximately 131 mm including the ends. The inner diameter is 22.2 mm. Before installation, check the clearance for the throttle and brake lever; do not force the shorter right grip onto a twist throttle.

Palm rest and grip adjustment

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure the new grip is fully seated on the intended section of the tube.
• Adjust the position for a relaxed wrist and comfortable reach to the brake lever. Tighten the locking components (where present) according to instructions and ensure the grip does not rotate.
• Verify smooth throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.