Black ergonomic grips for VSETT 8+

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm support. Clamps on both ends limit the rotation of a correctly installed grip on the handlebar.

Features and fitment

• Model: VSETT 8+.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force a replacement of a shorter right-side grip near a rotating throttle.

Adjusting support and grip

• Remove the old grips, and clean and dry the handlebars. Before fastening, ensure the new grip fits completely onto the intended part of the tube.
• Adjust the position for relaxed wrist posture and brake lever reach. Tighten the clamping parts, where present, according to the instructions and verify that the grip does not rotate.
• Verify smooth return of the throttle. Replace torn, hardened, or slippery grips; do not apply lubricants to the grip surface.