Black ergonomic grips for VSETT 9 – 120 mm grip length, 131 mm total

Ergonomic black grips with locking collars on both ends

The pair of black grips features a textured surface and extended palm support. Locking collars on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: VSETT 9.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; collars on both ends.

Approximate dimensions

• Length of grip area: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space for the throttle and brake lever; do not force the replacement of shorter right-side grips near a twist throttle.

Support and grip adjustment

• Remove the old grips, then clean and dry the handlebar. Before tightening, check that the new grip sits completely on the intended part of the tube.
• Adjust the position for a relaxed wrist and access to the brake lever. Tighten the locking parts (where present) according to the instructions and ensure the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricants to the gripping surface.