Black ergonomic grips for VSETT 9 Apex+ – grip area 120 mm, total 131 mm

Ergonomic black grips with dual locking clamps

This pair of black grips features a textured surface and an extended palm rest. Clamps on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: VSETT 9 Apex+.
• Pair of black ergonomic grips with palm rest.
• Grip area 120 mm; total length 131 mm.
• Clamp size 22.2 mm; dual locking clamps.

Approximate dimensions

• Length of grip area: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Palm rest width: 44 mm.
• Clamp diameter: 22.2 mm.

The grip area is 120 mm, with a total length including end caps of approximately 131 mm. Inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force the shorter right grip if it interferes with the twist throttle.

Adjustment and setup

• Remove the old grips, then clean and dry the handlebar. Before securing, ensure the new grip fits fully onto the designated section of the tube.
• Adjust the position for a relaxed wrist and comfortable brake lever reach. Tighten the locking clamps according to instructions and ensure the grip does not rotate.
• Check for proper throttle return. Replace any grips that are torn, hardened, or slippery; do not apply lubricant to the grip surface.