Black ergonomic grips for VSETT 9+

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and an extended palm rest. The clamps on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: VSETT 9+.
• Pair of black ergonomic grips with palm rest.
• Grip area 120 mm; total length 131 mm.
• Mount 22.2 mm; clamps on both ends.

Approximate dimensions

• Length of grip area: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Width of rest: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, with the total length including ends being approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space by the throttle and brake lever; do not force the replacement of shorter right grips near a twist throttle.

Adjusting the rest and grip

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure that the new grip sits completely on the intended part of the tube.
• Adjust the position to your relaxed wrist and the reach of the brake lever. Tighten the clamping parts, where present, according to the instructions and check that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.