Black ergonomic grips for VSETT Mini – 120 mm grip area, 131 mm total length

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm rests. Clamps on both ends restrict the rotation of properly installed grips on the handlebars.

Features and fitment

• Model: VSETT Mini.
• Pair of black ergonomic grips with palm rests.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Check for clearance around the throttle and brake lever before installation; do not force the shorter right-side grip over the twist throttle.

Adjusting the rest and grip

• Remove the old grips, then clean and dry the handlebars. Before securing, ensure that the new grip sits fully on the designated part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping parts, where present, according to the instructions and verify that the grip does not rotate.
• Verify that the throttle returns freely. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.