Black ergonomic grips for Joyor C10 DGT – 120 mm grip length, 131 mm total

Ergonomic black grips with clamps on both ends

This pair of black grips features a textured surface and an extended palm rest. The clamps on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: Joyor C10 DGT.
• Pair of black ergonomic grips with palm rests.
• Grip area 120 mm; total length 131 mm.
• Mounting diameter 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force the installation of a right grip that is too long next to a twist-throttle.

Rest and grip adjustment

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure that the new grip sits completely on the intended part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping components, where present, according to instructions and ensure that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricants to the grip surface.