Black ergonomic grips for Joyor Y10 DGT – grip 120 mm, total 131 mm

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm support. Clamps on both ends prevent the properly installed grip from rotating on the handlebar.

Features and compatibility

• Model: Joyor Y10 DGT.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Length of grip area: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Width of support: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space next to the throttle and brake lever; do not force a replacement with a shorter right grip if a twist throttle is present.

Adjusting support and grip

• Remove old grips, then clean and dry the handlebar. Before fastening, ensure the new grip is fully seated on the intended part of the bar.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping parts, where present, according to the instructions and ensure the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.