Black ergonomic grips for VSETT 10 Apex

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and an extended palm rest. Clamps on both ends prevent the correctly installed grip from rotating on the handlebar.

Features and Compatibility

• Model: VSETT 10 Apex.
• Pair of black ergonomic grips with palm rests.
• Gripping area 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate Dimensions

• Length of gripping area: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Width of palm rest: 44 mm.
• Mounting diameter: 22.2 mm.

The gripping area measures 120 mm, and the total length with the end pieces is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space next to the throttle and brake lever; do not force a replacement with shorter right-side grips next to a twist throttle.

Adjusting Support and Grip

• Remove the old grips, then clean and dry the handlebars. Before fixing, check that the new grip is fully seated on the intended part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten clamping components, where present, according to instructions and ensure the grip does not rotate.
• Check the free return of the throttle. Replace torn, hardened, or slippery grips; do not apply lubricants to the grip surface.