Black ergonomic grips for VSETT 10+ Super

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and an extended palm rest. Clamps on both ends prevent the correctly installed grip from rotating on the handlebar.

Features and fitment

• Model: VSETT 10+ Super.
• Pair of black ergonomic grips with palm rest.
• Grip section 120 mm; total length 131 mm.
• Mount 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Rest width: 44 mm.
• Mount diameter: 22.2 mm.

The grip section measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force-replace a shorter right-hand grip if you have a twist throttle.

Rest and grip adjustment

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure the new grip is fully seated on the designated part of the tube.
• Adjust the position to suit your relaxed wrist angle and brake lever reach. Tighten the locking mechanisms, if present, according to instructions and check that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricants to the gripping surface.