Black ergonomic handlebar grips for VSETT 11+ – grip area 120 mm, total 131 mm

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm support. Clamps on both ends restrict the rotation of properly installed grips on the handlebar.

Features and fitment

• Model: VSETT 11+.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• 22.2 mm mounting; clamps on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space next to the throttle and brake lever; do not force the shorter right grip onto a rotating throttle.

Adjusting support and grip

• Remove the old grips, then clean and dry the handlebar. Before tightening, check that the new grip sits fully on the designated part of the tube.
• Adjust the position for a relaxed wrist and access to the brake lever. Tighten the clamping parts, where present, according to instructions and verify that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricants to the gripping surface.