Black ergonomic grips for Hiley Tiger 8 – 120 mm grip, 131 mm total

Ergonomic black grips with locking rings on both ends

The pair of black grips features a textured surface and extended palm support. Locking rings on both ends prevent the properly installed grip from rotating on the handlebars.

Features and compatibility

• Model: Hiley Tiger 8.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Clamp 22.2 mm; locking rings on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Support width: 44 mm.
• Clamp diameter: 22.2 mm.

The grip section measures 120 mm, with a total length of approximately 131 mm including the end caps. The inner diameter is 22.2 mm. Before installation, check the space next to the throttle and brake lever; do not force the installation of shorter right-side grips next to a twist throttle.

Support and grip adjustment

• Remove the old grips, then clean and dry the handlebars. Before securing, ensure that the new grip sits fully on the designated section of the tube.
• Adjust the position for a relaxed wrist and comfortable reach to the brake lever. Tighten the clamping parts, where present, according to the instructions and verify that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.