Black ergonomic grips for Joyor C10 – 120 mm grip, 131 mm total

Ergonomic black grips with locking clamps at both ends

This pair of black grips features a textured surface and an extended palm rest. The locking clamps at both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: Joyor C10.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Mounting diameter 22.2 mm; clamps at both ends.

Approximate dimensions

• Grip length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Palm rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, with a total length including end caps of approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space available near the throttle and brake lever; do not force the installation of shorter right-side grips on a twist throttle.

Palm rest and grip adjustment

• Remove the old grips and clean and dry the handlebar. Before fastening, ensure the new grip fits fully onto the designated section of the tube.
• Adjust the position to suit a relaxed wrist and the reach to the brake lever. Tighten the locking components where present according to the instructions and ensure the grip does not rotate.
• Check for free return of the throttle. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.