Black ergonomic grips for Joyor LiteGo – 120 mm grip, 131 mm total

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm support. Clamps on both ends restrict rotation of a properly installed grip on the handlebar.

Features and compatibility

• Model: Joyor LiteGo.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, and the total length with the ends is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force the replacement of a shorter right-hand grip if it is near a rotating throttle.

Adjusting support and grip

• Remove the old grips, and clean and dry the handlebar. Before tightening, check that the new grip is fully seated on the intended part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping parts, where present, according to instructions and verify that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.