Black ergonomic grips for Joyor S10-S-Z – grip 120 mm, total 131 mm

Ergonomic black grips with clamps at both ends

The pair of black grips features a textured surface and extended palm rest. Clamps at both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: Joyor S10-S-Z.
• Pair of black ergonomic grips with palm rest.
• Grip part 120 mm; total length 131 mm.
• Clamp 22.2 mm; clamps at both ends.

Approximate dimensions

• Grip part length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Rest width: 44 mm.
• Clamp diameter: 22.2 mm.

The grip part measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance near the throttle and brake lever; do not force the replacement of shorter right grips near a twist throttle.

Adjusting the rest and grip

• Remove the old grips, then clean and dry the handlebar. Before attaching, check that the new grip sits completely on the intended part of the bar.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping parts, where present, according to the instructions and verify that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.