Black ergonomic grips for Joyor S5-Z – grip 120 mm, total 131 mm

Ergonomic black grips with locking rings on both ends

The pair of black grips has a textured surface and extended palm support. Locking rings on both ends prevent the properly installed grip from rotating on the handlebars.

Features and fitment

• Model: Joyor S5-Z.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Clamp 22.2 mm; locking rings on both ends.

Approximate dimensions

• Length of the grip area: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Support width: 44 mm.
• Clamp diameter: 22.2 mm.

The grip area measures 120 mm, and the total length with the ends is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance around the throttle and brake lever; do not force the replacement of shorter right-side grips next to a twist throttle.

Adjusting support and grip

• Remove the old grips, then clean and dry the handlebars. Before securing, check that the new grip sits completely on the intended part of the tube.
• Adjust the position for a relaxed wrist and comfortable reach of the brake lever. Tighten the locking parts, where present, according to instructions and verify that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.