Black ergonomic grips for Joyor S8E – 120 mm grip, 131 mm total

Ergonomic black grips with locking rings on both ends

This pair of black grips features a textured surface and flared palm support. Locking rings at both ends prevent the correctly installed grip from rotating on the handlebar.

Features and fitment

• Model: Joyor S8E.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; locking rings on both ends.

Approximate dimensions

• Grip length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area is 120 mm, and the total length including the end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force a replacement if the right grip is shorter due to a rotating throttle.

Setting up support and grip

• Remove old grips and clean and dry the handlebar. Before securing, verify the new grip fits fully onto the designated tube area.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the locking components (where present) according to instructions and check that the grip does not rotate.
• Check the throttle for free return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.