Set of 22 mm anti-slip handlebar grips for ZERO 8X electric scooter

Ergonomic palm rest and locking clamps

The pair of black grips features an extended palm rest and a textured grip surface. Each grip is secured to the respective handlebar using a locking ring.

Features and fitment

• Model: ZERO 8X.
• Pair of black ergonomic grips with clamps; length approx. 127 mm; handlebar 22 mm.

Approximate dimensions

• Grip length: 127 mm.
• Diameter at inner end: 32 mm.
• Palm rest width: 46 mm.
• Width at clamp: 39.5 mm.
• Nominal handlebar diameter: 22 mm.

Length is approx. 127 mm, and nominal handlebar diameter is 22 mm. Before choosing, measure the available length past the throttle and brake levers. Set the palm rest angle according to a natural wrist position and verify that the grip does not rotate.

Setting palm rest and grip angle

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure the new grip is fully seated on the designated tube area.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping parts, where applicable, according to instructions and ensure the grip does not rotate.
• Check for smooth throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.