Adjustable bike stand – M6 mount, 40 mm spacing for ENGWE Engine Pro 2.0

Shorter adjustable kickstand with an extended foot

The black kickstand for a compatible 20–22-inch bike has two mounting points and an extendable lower leg. The extended foot increases the contact surface on the ground.

Features and fitment

• Model: ENGWE Engine Pro 2.0.
• Black adjustable kickstand; length approximately 308–367 mm.
• Mounting: two M6 holes with 40 mm spacing.

Approximate dimensions

• Adjustable kickstand length: 308–367 mm.
• Mounting plate: 60 × 22 mm.
• Mounting: M6 screws, 40 mm spacing.

The length is adjustable from approximately 300 to 367 mm. A suitable mounting point with 40 mm spacing and M6 threads is required. Adjust the tilt of the parked bike and check clearance from the chain and rear brake.

Two M6 threaded holes with 40 mm spacing are required on the corresponding left rear part of the frame. Also, check the required kickstand length and the space near the brake and chain.

Stable support when parking

• Attach the kickstand to the intended part of the frame and adjust the length for a moderate tilt of the parked vehicle. A setting that is too short or too long will reduce stability.
• Check that the folded kickstand does not hit the wheel, brake, or drivetrain parts. The vehicle should stand stable on a firm surface before you release your grip.
• The kickstand is designed for parking. Do not load it with additional body weight while sitting on the vehicle, and check the mount and screws after any strong impact.