Black ergonomic grips for KuKirin C1 Pro – grip length 120 mm, total 131 mm

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and extended palm support. Clamps on both ends limit rotation of the properly installed grip on the handlebar.

Features and fitment

• Model: KuKirin C1 Pro.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, with the total length including ends being approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the clearance next to the throttle and brake lever; do not force a replacement for the shorter right grip next to a twist throttle.

Adjusting the support and grip

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure the new grip is fully seated on the designated part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the clamping parts, where present, according to instructions and check that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.