Black ergonomic grips for KuKirin G2 Master – 120 mm grip, 131 mm total

Ergonomic black grips with clamps on both ends

This pair of black grips features a textured surface and extended palm support. Clamps on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: KuKirin G2 Master.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Mounting diameter 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, with a total length of approximately 131 mm including the ends. The inner diameter is 22.2 mm. Before installation, check the clearance around the throttle and brake lever; do not force the shorter right-hand grip over a twist-throttle.

Adjusting the support and grip

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure the new grip fits fully onto the intended part of the bar.
• Adjust the position for a relaxed wrist and comfortable brake lever reach. Tighten the locking parts (where present) according to the instructions and verify that the grip does not rotate.
• Check that the throttle returns freely. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.