Black ergonomic grips for Langfeite Coupe – 120 mm grip, 131 mm total

Ergonomic black grips with locking collars on both ends

The pair of black grips features a textured surface and extended palm support. Locking collars on both ends prevent the properly installed grip from rotating on the handlebars.

Features and fitment

• Model: Langfeite Coupe.
• Pair of black ergonomic grips with palm support.
• Grip area 120 mm; total length 131 mm.
• Mounting 22.2 mm; locking collars on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space next to the throttle and brake lever; do not force a shorter right grip over a rotating throttle.

Support and grip adjustment

• Remove the old grips, then clean and dry the handlebars. Before fastening, check that the new grip sits completely flush on the intended part of the tube.
• Adjust the position to match a relaxed wrist position and brake lever reach. Tighten the locking parts (where applicable) according to the instructions and ensure the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.