Black ergonomic grips for Langfeite H1

Ergonomic black grips with locking collars on both ends

The pair of black grips features a textured surface and an extended palm rest. Locking collars on both ends prevent the properly installed grip from rotating on the handlebar.

Features and fitment

• Model: Langfeite H1.
• Pair of ergonomic black grips with palm rest.
• 120 mm grip area; 131 mm total length.
• 22.2 mm mount; locking collars on both ends.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Palm rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area is 120 mm long, and the total length with end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force a replacement with a shorter right grip on a twist throttle.

Adjusting the palm rest and grip

• Remove the old grips, then clean and dry the handlebar. Before tightening, ensure the new grip is fully seated on the intended part of the tube.
• Adjust the position for a relaxed wrist and reach to the brake lever. Tighten the locking components, where present, according to the instructions and ensure the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.