Black ergonomic grips for Langfeite GT3 – grip 120 mm, total 131 mm

Ergonomic black grips with locking rings on both ends

This pair of black grips features a textured surface and an extended palm rest. The locking rings on both ends prevent the properly installed grips from rotating on the handlebars.

Features and fitment

• Model: Langfeite GT3.
• Pair of black ergonomic grips with palm rest.
• Grip section 120 mm; total length 131 mm.
• Mounting 22.2 mm; locking rings on both ends.

Approximate dimensions

• Length of the grip section: 120 mm.
• Total length: 131 mm.
• Diameter at the inner end: 32 mm.
• Width of the palm rest: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, and the total length with the end caps is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space around the throttle and brake lever; do not force the shorter right-side grip onto a twist throttle.

Palm rest and grip adjustment

• Remove the old grips, then clean and dry the handlebars. Before securing, check that the new grip sits fully on the designated part of the bar.
• Adjust the position for a relaxed wrist and easy reach to the brake lever. Tighten the locking components (if present) according to the instructions and ensure the grip does not rotate.
• Check for free return of the throttle. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.