Black ergonomic grips for Langfeite Roadster – grip 120 mm, total 131 mm

Ergonomic black grips with clamps on both ends

The pair of black grips features a textured surface and an extended palm rest. Clamps on both ends prevent the correctly installed grip from rotating on the handlebar.

Features and fitment

• Model: Langfeite Roadster.
• Pair of black ergonomic grips with palm rest.
• Grip part 120 mm; total length 131 mm.
• Mounting 22.2 mm; clamps on both ends.

Approximate dimensions

• Grip part length: 120 mm.
• Total length: 131 mm.
• Diameter at inner end: 32 mm.
• Palm rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip part measures 120 mm, and the total length with the end pieces is approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the space next to the throttle and brake lever; do not force the replacement of shorter right-side grips near the twist throttle.

Adjusting support and grip

• Remove old grips and clean and dry the handlebar. Before fastening, check that the new grip fits fully onto the designated part of the tube.
• Adjust the position for a relaxed wrist and brake lever reach. Tighten the clamping parts, where present, according to the instructions and check that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the grip surface.