Black ergonomic grips for Teverun Fighter 11+ – grip 120 mm, total 131 mm

Ergonomic black handlebar grips with dual-end locks

Pair of black grips with a textured surface and flared palm rests. The dual-end locks prevent the grips from rotating once properly installed on the handlebar.

Features and fitment

• Model: Teverun Fighter 11+.
• Pair of black ergonomic grips with palm rests.
• Grip area 120 mm; total length 131 mm.
• Mounting diameter 22.2 mm; dual-end locking clamps.

Approximate dimensions

• Grip area length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Palm rest width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip area measures 120 mm, with a total length including the end caps of approximately 131 mm. The inner diameter is 22.2 mm. Before installation, check the available space near the throttle and brake lever; do not force the installation of a shorter right-side grip next to a twist throttle.

Palm rest and grip adjustment

• Remove old grips, then clean and dry the handlebar surface. Before securing, ensure the new grip fits completely onto the designated part of the handlebar tube.
• Adjust the angle to suit your wrist position and brake lever reach. Tighten the locking clamps (where present) according to the instructions and ensure the grip does not rotate.
• Verify that the throttle returns freely. Replace any torn, hardened, or loose grips; do not apply lubricants to the grip surface.