DC 5.5 × 2.1 mm charging socket for KuKirin G2

DC charging port with thread and protective cap

The 5.5 × 2.1 mm DC charging port has a threaded mounting section and a black rubber cap. The red and black wires terminate in a red two-pin connector.

Features and fitment

• Model: KuKirin G2.
• DC 5.5 × 2.1 mm charging port.
• Threaded mount, rubber cap, red-black wires, and red connector.

Approximate dimensions

• Cable length with port: 132 mm.
• Mounting part diameter: 10 mm.
• Charging connector: DC 5.5 × 2.1 mm.

The wired part measures approximately 13.2 cm. Before replacement, check the opening in the housing, polarity, and the existing connector. Close the cap after charging to limit dirt entry into the contacts.

Connecting and protecting the wiring

• Before performing work, disconnect the power according to the device's instructions. Compare the shape of the connectors, polarity or signal layout, and contact condition.
• Connect joints without force and protect them according to the installation location. Route the cable away from sharp edges and moving parts.
• Check that the wiring is not pinched during steering or folding. Before powering on, verify the polarity and signal contact layout.