DC 5.5 × 2.1 mm charging port for KuKirin G3

DC charging socket with thread and protective cap

The DC 5.5 × 2.1 mm charging socket features a threaded mounting part and a black rubber cap. The red and black wire ends with a red two-pin connector.

Features and fitment

• Model: KuKirin G3.
• DC 5.5 × 2.1 mm charging socket.
• Threaded mounting, rubber cap, red-black wires, and red connector.

Approximate dimensions

• Cable length with socket: 132 mm.
• Mounting part diameter: 10 mm.
• Charging connector: DC 5.5 × 2.1 mm.

The wired part measures approximately 13.2 cm. Before replacing, check the opening in the housing, the polarity, and the existing connector. Close the cap after charging to limit dirt ingress into the contacts.

Connection and wiring protection

• Before performing the work, disconnect the power according to the device's instructions. Compare the shape of the connectors, the polarity or signal layout, and the condition of the contacts.
• Connect the joints without forcing them and protect them based on the installation location. Route the cable away from sharp edges and moving parts.
• Check that the wiring does not get pinched when steering or folding. Before switching on, verify the polarity and signal contact layout.