Pair of black grips, 125 and 92 mm, for KuKirin G2

Longer and shorter black grip for asymmetrical handlebars

The pair of rubber grips consists of an approximately 125 mm long grip and a 92 mm short grip. Both have a textured surface and a flared outer edge.

Features and fitment

• Model: KuKirin G2.
• Set of two black grips of different lengths.
• Longer grip approximately 125 mm, shorter approximately 92 mm.
• Embossed gripping surface and flared ends.

Approximate dimensions

• Grip lengths: 125 mm and 92 mm.
• Outer diameter: 29 mm.
• End flange diameter: 32.7 mm.
• Inner diameter: 21.5 mm.

The shorter grip leaves room for a twist throttle. Before replacing, compare the available length on both sides of the handlebar; after installation, the grips must not rotate or rub against the throttle.

Adjusting support and grip

• Remove the old grips, then clean and dry the handlebar. Before attaching, check that the new grip fits completely onto the intended part of the tube.
• Adjust the position for a relaxed wrist and reach of the brake lever. Tighten the clamping parts, where present, according to the instructions and check that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.