Pair of black grips 125 and 92 mm for KuKirin G2 Ultra

Long and short black grips for asymmetric handlebars

The pair of rubber grips consists of a long (approx. 125 mm) and a short (approx. 92 mm) grip. Both have a textured surface and an extended outer edge.

Features and fitment

• Model: KuKirin G2 Ultra.
• Set of two black grips of different lengths.
• Longer grip approx. 125 mm, shorter approx. 92 mm.
• Embossed grip surface and extended ends.

Approximate dimensions

• Grip lengths: 125 mm and 92 mm.
• Outer diameter: 29 mm.
• Outer flange diameter: 32.7 mm.
• Inner diameter: 21.5 mm.

The shorter grip leaves room for the twist throttle if applicable. Before replacing, compare the available length on both sides of the handlebar; after installation, the grips should not rotate or rub against the throttle.

Support and grip adjustment

• Remove the old grips, then clean and dry the handlebar. Before securing, ensure the new grip fits completely onto the intended section of the tube.
• Adjust the position for relaxed wrists and brake lever reach. Tighten the clamping parts, where present, according to the instructions and ensure the grip does not rotate.
• Check for smooth throttle return. Replace worn, hardened, or slippery grips; do not apply lubricants to the grip surface.