Pair of black 125 and 92 mm grips for KuKirin G3

Longer and shorter black grips for asymmetric handlebars

This pair of rubber grips consists of one approximately 125 mm long grip and one 92 mm short grip. Both feature a textured surface and an extended outer edge.

Features and fitment

• Model: KuKirin G3.
• Set of two black grips of different lengths.
• Longer grip approx. 125 mm, shorter approx. 92 mm.
• Embossed grip surface and extended ends.

Approximate dimensions

• Grip lengths: 125 mm and 92 mm.
• Outer diameter: 29 mm.
• Diameter of end edge: 32.7 mm.
• Inner diameter: 21.5 mm.

The shorter grip leaves space for a matching twist-throttle. Before replacing, compare the available length on both sides of the handlebar; after installation, the grips must not rotate or rub against the throttle.

Setting up support and grip

• Remove the old grips, then clean and dry the handlebars. Before fastening, check that the new grip sits fully on the intended part of the tube.
• Adjust the position for a relaxed wrist and ease of reaching the brake lever. Tighten the locking parts (if present) according to the instructions and verify that the grip does not rotate.
• Check for free throttle return. Replace torn, hardened, or slippery grips; do not apply lubricant to the gripping surface.