Black ergonomic grips for Kaabo Mantis 10 – 120 mm grip, 131 mm total

Ergonomic black grips with locking collars on both ends

The pair of black grips features a textured surface and extended palm support. Locking collars on both ends prevent the correctly installed grip from rotating on the handlebars.

Features and fitment

• Model: Kaabo Mantis 10.
• Pair of black ergonomic grips with palm support.
• Grip section 120 mm; total length 131 mm.
• Mounting diameter 22.2 mm; locking collars on both ends.

Approximate dimensions

• Grip section length: 120 mm.
• Total length: 131 mm.
• Inner end diameter: 32 mm.
• Palm support width: 44 mm.
• Mounting diameter: 22.2 mm.

The grip section measures 120 mm, with a total length including end caps of approximately 131 mm. Inner diameter is 22.2 mm. Check the clearance for the throttle and brake lever before installation; do not force the shorter right grip onto a twist throttle.

Palm support and grip adjustment

• Remove the old grips, then clean and dry the handlebar. Ensure the new grip fully seats onto the intended section of the tube before securing.
• Adjust the position for a relaxed wrist and comfortable brake lever reach. Tighten the locking components, where present, according to instructions and check that the grip does not rotate.
• Verify that the throttle return is unobstructed. Replace torn, hardened, or loose grips; do not apply lubricants to the gripping surface.